왔
The “Getting started” section provides an overview of the vehicle’s most basic func- tions. First-time Mercedes-Benz owners should pay special attention to the infor- mation given here.If you are already familiar with the basic functions described here, the “Controls in detail” section will provide you with further information. The corresponding page refer- ences are located at the end of each seg- ment.
Unlocking
Unlocking with the SmartKey
SmartKey
1‹Lock button
2ŠUnlock button for trunk lid
3ŒUnlock button
4ÂPanic button (컄page 73)
왘 Press unlock button Œ on the SmartKey.
All turn signal lamps flash once. The locking knobs in the doors move up. The SBC brake system is activated. 왘 Get in the vehicle and insert the
SmartKey in the starter switch. More information can be found in the “Controls in detail” section (컄page 88).
Getting started
Unlocking
Starter switch positions
Starter switch
0For removing SmartKey
1Power supply to some electrical con- sumers, such as seat adjustment
2Ignition (power supply for all electrical consumers) and driving position
3Starting position
Warning!
G
When leaving the vehicle, always take the SmartKey with you and lock the vehicle. Do not leave children unattended in the vehicle, or with access to an unlocked vehicle. Unsu- pervised use of vehicle equipment may cause an accident and/or serious personal injury.
i
The SmartKey can only be removed from the starter switch with the gear selector lever in positionP.
!
If the SmartKey cannot be turned, the battery may not be sufficiently charged.
왘 Check the battery and charge it if necessary (컄page 287). 왘 Get a jump start (컄page 378). To prevent accelerated battery dis- charge or a completely discharged bat- tery, always remove the SmartKey from the starter switch when the engine is not in operation.
Unlocking
Unlocking with KEYLESS-GO*
If you have the KEYLESS-GO function, your vehicle checks whether the SmartKey with KEYLESS-GO is valid when you pull the door handle. If your SmartKey is valid, the doors will unlock, and you can open them. The function of the SmartKey overrules the KEYLESS-GO function.
왘 Pull the door handle.
The turn signal lamps flash once. The locking knobs on the doors move up. The SBC brake system is activated. If the SmartKey is inside the vehicle, press- ing the KEYLESS-GO start/stop button on the gear selector lever corresponds to turning the SmartKey to the various starter switch positions.
i
To unlock the vehicle, the SmartKey with KEYLESS-GO must be outside the vehicle, no further than approximately 3 feet (1 meter) away from the door.
Warning!
G
When leaving the vehicle, always take the SmartKey with KEYLESS-GO with you, and lock the vehicle. Do not leave children unat- tended in the vehicle, or with access to an unlocked vehicle. Unsupervised use of vehi- cle equipment may cause an accident and/or serious personal injury.
Getting started
Unlocking
1KEYLESS-GO start/stop button Before you press the KEYLESS-GO start/stop button, the vehicle’s on-board electronics have status 0 (as with Smart- Key removed).
The SmartKey with KEYLESS-GO must be located in the vehicle.
왘 Make sure the gear selector lever is set toP.
왘 Do not depress the brake pedal.
Position 1
왘 Press the KEYLESS-GO start/stop but- ton once.
This supplies power to some electrical consumers, such as seat adjustment.
Ignition (or position 2)
왘 Press the KEYLESS-GO start/stop but- ton twice.
This supplies power to all electrical consumers. All the lights in the instru- ment cluster come on.
More information can be found in the “Controls in detail” section (컄page 91). For information on starting the engine us- ing the KEYLESS-GO start/stop button, see “Starting with KEYLESS-GO” (컄page 44).
i
If you now press the KEYLESS-GO start/stop button
앫 once again, the ignition (position2) is switched on.
앫 twice, the power supply is again switched off.
i
If you now press the KEYLESS-GO start/stop button once, the power sup- ply is again switched off.
Adjusting
왔Adjusting
Seats
Warning!
G
All seat, head restraint, steering wheel, and rear view mirror adjustments, as well as fas- tening of seat belts, must be done before the vehicle is put into motion.
Warning!
G
Do not adjust the driver’s seat while driving. Adjusting the seat while driving could cause the driver to lose control of the vehicle. Never ride in a moving vehicle with the seat back reclined. Sitting in an excessively re-
Your seat must be adjusted so that you can correctly fasten your seat belt (컄page 40). Never place hands under the seat or near any moving parts while a seat is being ad- justed.
Warning!
G
When leaving the vehicle, always remove the SmartKey from the starter switch, take the SmartKey with KEYLESS-GO* with you, and lock your vehicle.
The power seats can also be operated with the driver’s or passenger door open. Do not leave children unattended in the vehicle, or with access to an unlocked vehicle. Unsu- pervised use of vehicle equipment may
Warning!
G
Children 12 years old and under must never ride in the front seat, except in a
Mercedes-Benz authorized BabySmartTM compatible child seat, which operates with the BabySmartTM system installed in the ve- hicle to deactivate the passenger front air- bag when it is properly installed. Otherwise they will be struck by the airbag when it in- flates in a crash. If this happens, serious or fatal injury will result.
According to accident statistics, children are safer when properly restrained in the rear seating positions than in the front seat- ing positions. Infants and small children must ride in back seats and be seated in an appropriate infant or child restraint system,