• No results found

Optimization of Tremblay's battery model parameters for plug in hybrid electric vehicle application

N/A
N/A
Protected

Academic year: 2020

Share "Optimization of Tremblay's battery model parameters for plug in hybrid electric vehicle application"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1. A typical battery discharge characteristic. namely the fully charged voltage (
Table III. RWRSS and model parameters obtained using the GA, the PSO, and the QPSO parameter estimation techniques
Fig. 3. A comparison between the static capacity test curve and the simulated curves generated by Tremblay’s, GA, PSO, and QPSO parameter estimation techniques

References

Related documents

Subsequently, the fortified products became subject to sensory analysis, their antioxidant capacity was measured by the FRAP method, total polyphenols content was found

Rubber-Tired Earth Moving Equipment Operator, operating in Tandem (scrapers, belly dumps, and similar types in any combination, including compaction units - single

then obtained a list of 100,000 individuals who fit the targeted demographic profile from Mobile Interactive Agency (MIA), which had contracted with various website

There are two greyscale versions of the master logo ( one for use on light backgrounds and one for use on dark backgrounds) but these should only be used where the colour

I.Closed gradient measurement, immediately after complete fluid removal from the bottom,. measurement frequency is 200 m, and 50 m near the

Regarding the comparative effectiveness and safety of NOACs versus VKAs, only one retrospective cohort study provided some preliminary data, illustrating similar stroke/SE and

This documentary material has been researched in Europe at The British Museum (London), The National Museum of Ireland (Dublin), The Museum of Archaeology and

Greenville Technical College, Buck Mickel Center, Room 214, Pleasantburg Drive. Precision