• No results found

The resistivity and microstructure of heavily drawn Cu‐Nb alloys

N/A
N/A
Protected

Academic year: 2020

Share "The resistivity and microstructure of heavily drawn Cu‐Nb alloys"

Copied!
12
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

FIG~ L Resistivity vs temperature. Upper curve is for Cu-20 vol % Nb (no preannea!) at 17 = IO~ 9 ~ Lower curve is for pure Cu at 7/ = 1O~ 9 ~
FIG. 2. Resistivity vs temperature for Cu-20 vol % Nb (no prealllleal) at 1J = 11.9.
TABLE H. Sample characterization from an TEM analysis of wires drawn to 1/ = 10.9 value
FIG. 4. The two upper curves are theO 'C resistivity of the as-drawn wire vs D"I D, while the lower curve is the 0 'C resistivity of the same material after the heating cycle 10 810 'c
+3

References

Related documents

b In cell B11, write a formula to find Condobolin’s total rainfall for the week.. Use Fill Right to copy the formula into cells C11

○ If BP elevated, think primary aldosteronism, Cushing’s, renal artery stenosis, ○ If BP normal, think hypomagnesemia, severe hypoK, Bartter’s, NaHCO3,

were by right the emperors whom Christ and St Peter had commanded that all Christians should obey. The exalted nature of the emperor’s position was reflected in his

All of the participants were faculty members, currently working in a higher education setting, teaching adapted physical activity / education courses and, finally, were

An analysis of the economic contribution of the software industry examined the effect of software activity on the Lebanese economy by measuring it in terms of output and value

The purpose of this study was to evaluate the diagnostic utility of real-time elastography (RTE) in differentiat- ing between reactive and metastatic cervical lymph nodes (LN)

Results of the survey are categorized into the following four areas: primary method used to conduct student evaluations, Internet collection of student evaluation data,

If the roll is equal to or higher then the model's shooting skill then it hits and wounds as described in close combat.. If the roll was lower then the model's shooting skill then