23 Ccna Security Lab Manual [ PUNISHER ] pdf

Telnet from the command prompt (or use a terminal program such as HyperTerminal or TeraTerm) to the IP address of the gateway device and enter privileged EXEC mode using the

Router (config- if)# end To exist to privileged EXEC mode, enter the exit command, or press Ctrl-z.. To enter subinterface

To configure a router you need to have a password for the Privileged EXEC mode using enable?. Router> enable

User Level EXEC Command Privileged Level EXEC Command Global Level CONFIG Command Interface Level CONFIG Command Loopback Interface CONFIG Command Virtual Interface CONFIG Command

Interface configuration From global configuration mode, specify an interface using an interface (or router) command Router(config-if)# Or Router(config- router)# To return

Enter show interface command at either the user EXEC or the privileged EXEC router prompt.. What type

Interface configuration From the global configuration mode, enter the interface type number command, such as interface serial 0..

Step 2: Enter the configure terminal command to enter global configuration mode.