• No results found

Friction stir welding of steel for marine applications

N/A
N/A
Protected

Academic year: 2019

Share "Friction stir welding of steel for marine applications"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1. The basic principle of friction stir welding.
Figure 2. Demonstration of low distortion in a 6m long weld made in a single pass in 6 mm thick steel
Figure 3 Single pass friction stir weld in 6mm thick carbon steel
Figure 4. Microstructure of mid-TMAZ [x1000, Etched] (a) Slow; (b) Intermediate 1; (c) Intermediate 2; (d) Fast
+2

References

Related documents

When we performed a sensitivity analysis, to calculate the nNO diagnostic accuracy in studies that only in- cluded PCD populations diagnosed by more than one test (combination of

Today, the driving VyStar philosophy continues to be offering quality member service, highly competitive pricing while giving members high-yielding savings products, low loan

Therefore, a utility that uses dynamic rating forecasting instead of the traditional seasonal rating needs a very reliable ampacity forecast (e.g. 98% confidence,

We found that in case of high W val- ues (like 4 seconds), generaly we have a poor detection probability, specifically in accelerations and decelerations moments. This is true even

C:\Users\Mike\Documents\lease.pdf RAM Un-encrypted Encrypted Master keys Cached file(s) Decrypted Cached

3 and not considered as benign or likely benign because: (i) it appears at very low allelic frequencies in databases (ExAC and Topmed: 0.0012%), (ii) a pathogenic variant on the

Meanwhile, the influences of these varied parameters (pressure sum, fiber blend ratio, and basis weight) on wet strength and dispersiblity of materials were systematically