• No results found

Comparison of optimised composite control charts: improved statistical process control for the manufacturing industry

N/A
N/A
Protected

Academic year: 2019

Share "Comparison of optimised composite control charts: improved statistical process control for the manufacturing industry"

Copied!
171
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1-3. The cycle of process monitoring and correction
Figure 1-4. Compressive mortar strength history courtesy of Cement Australia
Table 3-10. MRL and MRLOCV performance for two-component CCUSUM schemes
Figure 5-1. The probability of detecting a step shift using EWMA schemes with λ  = 0.05 to 0.55, for a step shift of 1 σ , ICARL = 400 observations, based on 100,000 simulated chart runs
+7

References

Related documents

Passed time until complete analysis result was obtained with regard to 4 separate isolation and identification methods which are discussed under this study is as

Geneva is in heaven as Jeff and Gucch fight, just like the Kaylee in the earlier soap scene. The Choco and Frances restrain

White-box Testing :-White Box Testing (also synonyms as Clear Box Testing, Open Box Testing, Glass Box Testing, Transparent Box Testing, Code- Based Testing or

Results: In this study, using a series of BC 5 F 4 nearly isogenic lines (NILs) that were derived from a cross between the Korean japonica cultivar Hwayeongbyeo and Oryza rufipogon ,

For depreciable assets acquired after July 1970 and in the case of hospitals and SNFs, before July 18, 1984, the historical cost must not exceed the lowest of (1) the acquisition

This course will enable pupils to develop practical vocational skills and to improve their employment prospects by developing a range of employability skills.. The

used to optimally match patients exclusively using opioids or NSAIDs for low back pain on variables such as age, gender, history of medical conditions, pain sensitivity, pain

The sensor pH, turbidity and DO will be kept at any water surface and the data captured by the sensor will be given to Arduino UNO, then the data are transmitted wirelessly