• No results found

Electric Profiler System Using Arduino

N/A
N/A
Protected

Academic year: 2019

Share "Electric Profiler System Using Arduino"

Copied!
24
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1.1: Project Block Diagram of Electric Profiler
Figure 2.1: Block diagram of electric profiler
Figure 2.2: Arduino UNO
Figure 2.3: ACS712 Current Sensor
+3

References

Related documents

Huberty et al BMC Pregnancy and Childbirth 2014, 14 391 http //www biomedcentral com/1471 2393/14/391 RESEARCH ARTICLE Open Access Physical activity and depressive symptoms after

Results: C3b-induced degranulation resulted in increased release of ECP and MPO from primed blood eosinophils and neutrophils in both allergic rhinitis and allergic asthma during

Boston Public Library, Rare Book Department (photo courtesy of Walker, Sarah Wyman Whitman Bindings, BPL Flickr Photostream)... Book cover by Sarah Wyman Whitman for Oliver

Application of an analysis of variance (ANOVA) model indicated that the total variation in exposure across the entire sample population was partitioned as follows: 79% within-worker,

After the passengers board or deboard the bus, the ultrasonic sensor sends the signals to the arduino board, and the motor as well as the pinion gear rotates in the clockwise

The standard states: In any workplace where respirators are necessary to protect the health of the employee or whenever respirators are required by the employer, the employer

To begin addressing San Francisco and the fi eld’s concerns about recruiting and developing a strong, committed and valued workforce, the Community Network for Youth Development

For a higher degree of curvature (i.e., higher angle of incidence), more shift to a higher AMC resonant frequency is observed (2.7 GHz), while the reflection phase becomes steeper