Electrodeposition and Characterization of Nickel–TiN Microcomposite Coatings

Figure 5 shows the anodic polarization behavior of bare, pure chromium coated and Cr-nano TiO 2 coated samples in seawater and Table. 3 show the

In case Table 5 Corrosion parameters obtained by potentiodynamic polarization studies of bare copper and copper covered with OI film in aqueous NaCl environment at

The effect of eugenol oil concentration on the anodic and cathodic polarization behavior of tin in 0.1 M Na 2 CO 3 solution has been studied by

The corrosion behavior of 2Cr12MoV turbine steel in early condensate in the presence of acetic acid was studied by weight loss test, surface analysis and Potentiodynamic

In the figure 5, is observed the behavior of the corrosion velocity and the polarization resistance, in function of the bilayers number, can be seen clearly that

Polarization curves and electrochemical impedance spectroscopy demonstrated that corrosion current density decreased and charge transfer resistance increased when the

Abstract- The nickel/fly ash composite plating was realized in the presence of sodium lauryl sulfate (SLS) as a stimulator in Watts bath. Morphology of coating was studied by

Electrochemical measurements (i.e. open circuit potential and anodic polarization) were carried out for a better understanding of the corrosion behavior as well as