• No results found

Wear maps for TiC composite based coatings deposited on 303 stainless steel

N/A
N/A
Protected

Academic year: 2019

Share "Wear maps for TiC composite based coatings deposited on 303 stainless steel"

Copied!
22
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1. Composition of the 303 stainless steel disk
Fig. 2. a) Microstructure of 303stainless steel base TiC coating surface magnification X500 and b) the EDX analysis of the 303 stainless steel base TiC coating
Fig. 3. SEM micrograph of the wear tracks, a) 2N normal load and 3cm.s-1 sliding speed, b) 4N normal load and 7 cm.s-1 sliding speed, c) 4N normal load and 11cm.s-1 sliding speed and d) 8N normal load and 15cm.s-1 sliding speed
Fig. 5. a) Wear rate vs normal load, b) Wear rate vs sliding speed of 303stainless steel against alumina
+7

References

Related documents

Their advantage, as opposed to other frequently used bankruptcy or credibility models, is the fact that they are based on the data about the Czech companies

Budget — This report reflects current month operating expenses and fiscal year- to-date expenses compared to fiscal year-to-date pro-rata budgeted amounts approved by the Board.. In

Second-Stage Mote System PM 2.5 Emission Factors and Rates for Cotton Gins: Method 201A Combination PM 10 and PM 2.5 Sizing Cyclones..

[Battery Info]: When you are using a battery pack that is compatible with Intelligent System, this option displays a screen where you can verify the battery charge (as a

In terms of road traffic, this connection has already been established by the new network of motorways, while in terms of railway trans- port the quality of

characteristics of instruction that accompanied student achievement in reading, writing, and English. It focused on English language arts programs in schools that had been trying

In this study classi fications were assigned to detected seismic events based on their band-ratios: If an event had more low-frequency energy than high-frequency energy it was classi

(ii) qualora il Cliente sia posto in liquidazione o sia dichiarato fallito, ovvero altrimenti assoggettato ad una procedura concorsuale. In tal caso, Axel potrà