• No results found

A numerical flow simulation of a mixed flow pump

N/A
N/A
Protected

Academic year: 2019

Share "A numerical flow simulation of a mixed flow pump"

Copied!
16
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1: Cross-section of the test pump.
Figure 2: Performance characteristics of the test pump.
Figure 3: Detail of the mesh on the hub and blades surfaces on rotor and stator.
Table 2: Measurement and prediction of pump head
+5

References

Related documents

It has been reported (Ref. 31) that high angle grain boundaries and fine packet size as well as the interweave AF microstructure showed good impact toughness and finer cleavage

Fatigue cracks generated fro m sharp weld defects are initial cracks that grow through either the w eld jo in t region or the base metal in accordance with Paris

We analyzed the performance of linear detectors for MIMO Spatial Multiplexing systems in Rayleigh fading. channel and AWGN channel for QPSK modulation, which

The effective rates at the current stage of the cur- rent sequence of each of the reactions consuming species are the reaction rates from the model output multiplied by fraction..

To admit a connection when- ever it is possible at all, a General Rates algorithm is developed; it computes an optimal rate vector with possi- bly different rates allocated on

Project lateness introduces rework and new tasks but it may also cause some pressure to eliminate tasks in an effort to reduce project length and/or cost (Figure 3.7)...

Management University Research Grant (SMU) to research the failure of international conventions to control transnational Asian crime business with Professor Mark Findlay.. The

single-cistron composition and the other of multiFle-cistron composition, is dis- cussed in relation to reciprocal recombination within a locus. I N the present study,