• No results found

Co existing tuberculosis and malignant mesothelioma with multiple sites venous thrombosis: a case report

N/A
N/A
Protected

Academic year: 2020

Share "Co existing tuberculosis and malignant mesothelioma with multiple sites venous thrombosis: a case report"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1 Chest x-ray showing ill defined radio opacity in fibrotic opacities with subsegmental atelectasis seen in bilateral left lower zone, upper zones and bilateral pleural effusion with ICD tube in situ on the right side
Fig. 2 CT venography chest and abdomen showing hypodense superior vena cava and infra renal inferior vena cava suggestive of thrombosis with mid ascites with omental thickening
Fig. 3 CT venography chest showing evidence of pulmonary thromboembolism and hypodense filling defect in the bilateral brachiocephalic veins right internal jugular vein

References

Related documents

MpsI is a good rapid identification method that identifies the most important Candida spp isolated from patients and recommends further studies to develop new

Therefore, when two cultures were used to produce hydrogen, not only the optimal LAB/PNSB ratio, but also the initial cell concentration should be optimized in order to overcome

(bottom-right panel) by place of residence between 2008 and 2011 in Mexican states, grouped as with amendment (in dark green), without amendment (in cyan) and the Federal

We invite unpublished novel, original, empirical and high quality research work pertaining to the recent developments & practices in the areas of Com- puter Science &

Based on results obtained from variance analysis table related to chemical elements of water (Table 2) in various treatments, only change ions bicarbonate, calcium, magnesium

Saowaros (2014) used DEA method to estimate the operating efficiency of Thai property insur- ance Company in 2000-2007, the results show- ed that 74%-79% of non-life insurance

For an AM process whose toolpath is a set of lines such as fused deposition modeling (FDM), this thesis develops a line based topology opti- mization using the principal stress