• No results found

The Effect of Strain Rate on the Impact Behaviour of Fe 2 mass% Ni Sintered Alloy

N/A
N/A
Protected

Academic year: 2020

Share "The Effect of Strain Rate on the Impact Behaviour of Fe 2 mass% Ni Sintered Alloy"

Copied!
7
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1Characteristics of carbonyl iron and nickel powders as the startingmaterials.
Fig. 1Schematic presentation of the compression split-Hopkinson bar apparatus.
Fig. 2True stress-strain curves of Fe–2Ni sintered alloy deformed atdifferent strain rates.
Table 3. It is clear that for a given true strain level, �d is
+4

References

Related documents

In this study, WQI estimation in water samples surrounding the Jawaharnagar dumpsite for drinking purposes was found ranging from 65.3 to 179.9 which means that 71.2

phenomenon caused by a discontinuity in the passive film at a crack tip [19, 30, 35] (Figure 9). In dissolution–based models of SCC, the passive film at the crack tip ruptures

Response surface methodology was employed to describe the effects of cooking time and leaf quantity on iron, folic acid and phytate contents of sweet potato leaves

Focusing first on Table 9a, we see clearly that in the sample of schools where girls outperform boys on average the upper panel of Table 9a, the coefficients of the interaction

They are operating on UWB using practical antennas designed on CST Microwave studio, the obtained channel matrix from CST has been used for further coding MIMO, symbol Error

The Hello flood attacks in wireless sensor network can be caused by a node which broadcasts a Hello packet. with very high transmission power to sender or

6.1 Fault detection and isolation Scheme for actuator and flywheel spin rate sensor faults Assuming a single fault at any time, possible faults affecting the actuated reaction

Ebru Goca Assistant Editor / Turkish Representative Office Turkey IRI / The Marshall Islands Registry Ms.. Basak Gokkilic Business Development Manager