• No results found

Mechanical Properties of Platinum Jewellery Casting Alloys89-99

N/A
N/A
Protected

Academic year: 2020

Share "Mechanical Properties of Platinum Jewellery Casting Alloys89-99"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table I Tensile Properties and Hardnessa
Fig. 1. (a) and (c) 95Pt-Ru-Ga+ in the as-cast condition; (b) and (d) 95Pt-Ru-Ga+ in the HIP condition
Figure 3 shows the temperature-concentration (isopleth) section of the Pt-Ru-Ga system at 95  mass% platinum
Fig. 4. Hardness distributions for three different alloys with different precipitation behaviour
+2

References

Related documents

g) Place the cool chippings in the 5.0 L tin ( 3.3.5) half filled  with 1.18 mm to 600 mm silica sand.. h) Resieve the chippings using the 3.35 mm BS test sieve and wash with a

Just look for the percent symbol or the word “percent.” In this exercise, 12% is the rate.. The base is

A projection, along [010], of part of the crystal structure of (II), showing a cross-section of the (100) sheet with the hydrogen bonds linking the oxadiazine molecules in the

This thesis is a critical evaluation of the impact of service delivery shifts within maternity care on the clinical governance of a well-defined geographical service delivery

core loading in Cycle 22 have been used for generating a large number of randomly generated fuel loading patterns, which were then divided into training and testing data sets and

Evolution of the effective domain radius (circles), when a field square pulse of h = 0.07 is applied (also shown, with dashed lines) in a system at zero temperature and with a

Management (EM)) terhadap pesakit yang menghadapi masalah ketidaksuburan tanpa sebab, berbanding dengan pesakit yang menggunakan rawatan hiperstimulasi ovary terkawal

This intraocular lens is necessary to focus the light on the retina (the film on the back of eye). This lens implant is permanent and you will not feel it.. The specialty