• No results found

Preparation of Silica Powder in Epoxy Resin Wear Resistant Coating

N/A
N/A
Protected

Academic year: 2020

Share "Preparation of Silica Powder in Epoxy Resin Wear Resistant Coating"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1. Silicon powder particle size distribution.
Table 1. Modified silica powder sedimentation test results.
Figure 3. FT-IR of silicon powder before and after modification.
Figure 6. TG spectra before and after the modification of epoxy resin.
+2

References

Related documents

Within this framework, it was assumed that trends in office rental values, service sector output, employment in banking-finance-insurance and the real Treasury Bill rate will

Unlike the default sample, bond volume and number of transactions do not increase nearly as much, but bond liquidity is lower (which would cause a decline in premium ) based on the

c) Review of Teaching Materials. The evaluation of teaching involves multiple sources of data, each with its own unique contribution, including peer review of substantive

Figure 4 Prolyl hydroxylase inhibition and hypoxia increases cilia length and is associated with accumulation of HIF-2 α at the cilium.. (B) Primary cilia length with prolyl

Michigan Curriculum Framework (2006), which provided the structure for the Michigan Merit Curriculum, the Michigan State Board of Education and the Michigan Department of Education

Source; European Commission According to analysts of the European Commission the impact of the world recession is strongly felt by EU labour markets. The forecast end

The basic premise of the EL CID test significance level of +/-100 mA is that this level represents a 5 to 10 degrees C temperature rise that would be seen on flux test and