• No results found

Characteristics of Resistance Spot Welding for 1 GPa Grade Twin Induced Plasticity Steel

N/A
N/A
Protected

Academic year: 2020

Share "Characteristics of Resistance Spot Welding for 1 GPa Grade Twin Induced Plasticity Steel"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1Chemical composition (mass%).
Figure 4shows
Fig. 4Lobe diagram of DP980 and TWIP980. (a) Lobe diagram of DP980 (b) Lobe diagram of TWIP980.
Fig. 6Microstructure of DP980 and TWIP980, (a) BM, HAZ and nugget of DP980 (b) BM, HAZ and nugget of TWIP980.
+3

References

Related documents

The aim of the study is to prepare the gastroretentive floating tablets by using different concentrations of polymer and different methods and compressed by

For other uses you need to obtain permission from the rights-holder(s) directly, unless additional rights are indicated by a Creative Commons license in the record and/or on the

KEYWORDS: Building Information Modeling (BIM), Virtual Reality (VR), 3D Game Engine, Integrated Facility Management (IFM), Design Review of Healthcare

Total installed costs are about $5,000/ft 2 of electrically active floor area (including both IT and site infrastructure equipment).. On an annualized basis, the most

A field experiment was carried to investigate the physiolo- gical response of four tomato cultivars (Fetan, Chali, Cochoro and ARP Tomato d2) to moderate water deficit induced

44: Crossing Phase: Driver/Vehicle Turned right 45: Approaching Phase: Vehicle Stopped for observed pedestrian 46: Crossing Phase: Driver/Vehicle Accelerated 47: Approaching

Results indicated that since Firm 1 exercises its market power mainly through its hydro resources, the divestiture of the thermal plants would have a negligible effect in the degree

- volatility of payment risk for the transfer capacity right of use, related to the volatility of the electricity price in space, derived from grid congestions and, to the formation