• No results found

Investigation of Joining Micro-Foil Materials with Selective Laser Sintering and Laser Powder Deposition

N/A
N/A
Protected

Academic year: 2021

Share "Investigation of Joining Micro-Foil Materials with Selective Laser Sintering and Laser Powder Deposition"

Copied!
97
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 3. Graphic representation of an aspect ratio for a heat sink (Thermshield, 2008)
Figure 4. Current well screen design that must incorporate support rods and thicker v- v-shaped wire to achieve joining
Figure 5. Graphic representation of the SLS process (Morgan, Sutcliffe, & O’Neill,  2004)
Figure 6. Picture of a ball forming in the powder bed with the surrounding powder  having been pulled into the ball (Tolochko et al., 2004)
+7

References

Related documents

It is proposed that maternal breastfeeding and the provision of human milk for NICU infants and graduates may provide a protective factor against child maltreatment and

Dissertation Report for Master of Science in Facility & Environment Management 51 Question 2 - Do you agree that the current methods used by your organisation on procurement

Different configurations of hybrid model combining wavelet analysis and artificial neural network for time series forecasting of monthly precipitation have been developed and

For the poorest farmers in eastern India, then, the benefits of groundwater irrigation have come through three routes: in large part, through purchased pump irrigation and, in a

This study includes two different stages; the first one is about the effect of commercial feeding protocol on protease enzyme alteration and the second one is

This ethnographic study examines the social effects of the introduction of an enterprise-level quality control program (CMMI) on professional engineers in a complex

Histological examination of rabbit globes following this mode of cryo- application also showed a number of undesirable side effects, pri- marily disruption of the