Brief introduction

A-1

Brief introduction---03

Specification---03

Caution--- 04

Safety instruction for Li-Poly battery---05

Assembly--- 06

Package Contents---03

Safety Precautions---04

Caution---05

Preparation Prior to Flight---08

Instructions for Flight---09

Center of Gravity---10

◆Wingspan: 1600mm (63 inch)

◆Length: 1232mm (48.5 inch)

◆Flying Weight: 2800g (99 oz)

◆Motor: Brushless Kv400 Motor

◆Propeller: 4-Paddle

◆ESC: 80A Brushless ESC w/ BEC

◆

◆Retract: 90 Degree Rotating Servoless Retracts

◆Battery: 14.8V 3200mah 20C Li-Polymer

◆Control system: 6CH 2.4GHz Radio

Servo: 4X 9g and 2X 40g

Package Contents

Specification

Thank you for purchasing A-1 Skyraider radio controlled model airplane. It’s very convenient for you to

maintain this model due to the removable horizontal tail, vertical tail and main wings. This model airplane is

2. Warnings listed in the instructions must be read carefully and heeded.

RC aircrafts or computer flight simulator softwares.

BlitzRCworks

Safety Precautions

Caution

1. This product is not a toy. Adult supervision is required for pilots under 14 years of age.

3. This plane should only be operated by experienced and advanced pilots.

4. Improper adjustments and operation will result in crashes and damages to the model.

5. Experience is required prior to handling this product and it can be obtained by practicing with novice

1. Do not fly during bad weather conditions such as strong winds, rain or thunderstorms.

2. Never fly the model around power lines, highways, subways or any high traffic areas.

4. Do not fly where there are other flying model planes with same frequency or there are other jamming radio waves nearby.

5. Make sure that the model, as well as the radio system, is in the good condition before flight.

7. Do not attempt to catch the plane by hand while the plane is flying.

8. This model is recommended for pilots over the age of 14 with experience. If pilot is younger or a novice then we recommend you get assistance from an experienced model pilot.

Safety instruction for Li-poly batteries

1. Use the original charger. Never charge the battery at more than 1.5 A.

2. Never discharge the battery at more than 5C. Do not discharge too long as this will damage the battery. 3. For full flight time to be achieved please cycle the cells through three flights.

5. In order to maintain the voltage and ensure the life time of the battery, please recharge it if it has not been used for more than three months.

Caution

01. Do not disassemble or reconstruct the battery. 02. Do not short-circuit the battery.

03. Do not use or leave the battery nearby a fire, stove or heated place. 04. Do not immerse the battery in water and do not get it wet.

05. Do not charge the battery nearby a fire or under the blazing sunlight. 06. Do not drive a nail into the battery, strike it by hammer or tread on it. 07. Do not impact or throw the battery.

08. Do not use a battery with conspicuous damage or deformation. 09. Do not make the direct soldering on the battery.

10. Do not reversely charge or over discharge the battery. 11. Do not reverse charge or reverse the connection.

12. Do not connect the battery to any ordinary charge socket or car cigarette jack. 13. Do not use the battery for unspecified equipment.

14. Do not touch a leaking battery directly; please wash the contact area or clothing with water if they come in contact with the liquid leaking from the battery.

15. Do not mix the Li-Poly battery with other un-chargeable battery . 16. Do not continue charging the battery over the prescribed time.

17. Do not put the battery into a microwave oven or high-pressure container. 18. Do not use an abnormal or deformed battery.

19. Do not use or keep the battery under direct sunlight.

20. Do not use the battery where there maybe static electricity (over 64V). 21. Do not charge the battery where the temperature is under 0 or over 45 . 22. If you find that the battery is leaking or shows abnormal symptoms, stop using it . 23. Keep the battery away from the children.

24. Use the specified charger and observe charging requirement (under 1.5A). 25. Parents should supervise and show the children the correct way to charge.

Assembly

rudder with screws elevator with screws aileron with screws

in the fixed position on and wheel cover on the wheel cover with screws landing gear plastic.

the main wing. wires of aileron and flap.

the servo arm.

and flap servos. and flap then buckle them into the horn.

13. Insert the wing rod into

4. Connect the wires of

5. Install the landing gear 6. Install the fixed holder 7. Fix the holder and 8. Tie the soft wire to the

10. Install the push rod for aileron 1. Install the horn on 2. Install the horn on 3. Install the horns on

11. Adjust the clevis of aileron

12. Glue the missiles and tanks onto the main wing. 14. Connect the extension

wire of landing gear. of tail landing gear with 15. Connect the extension 16. Connect the steel wire

9. Bind the soft wire and wheel cover.

17. Crimp the line with pliers. landing gear.

the wing. electric retracts.

(PB2.0X30mm 4pcs). (PB2.0X15mm 4pcs). (PB2.0X15mm 8pcs).

(PM3.0X40mm 2pcs).

(PM3.0X50mm 2pcs).

(PM3.0X40mm 2pcs). steel rod with the horn on rudder.

steel rod with the horn on the elevator.

parts on the fuselage. the fuselage.

18. Connect soft steel wire the servo arm of tail landing gear. 19. Install horizontal tail wing on the fuselage with screws

19. Install vertical tail wing on the fuselage with screws _{20. Connect the controlling} 21. Connect the controlling

22. Install main wings on the fuselage with screws 23. Glue the decorating 24. Glue the antenna on

25. Glue canopy on the cockpit.

26. Install the propeller adapter on motor with screws and 27. Install the propeller on nut the propeller adapter.

Preparation Prior to Flight

closed before powering up the transmitter. Then connect the battery to the ESC of the model airplane and place the battery in its proper position. Make sure the switch on the transmitter is in the "OFF" position. Insert the 8 AA batteries in the transmitter. Ensure that the throttle is fully

hit any person or any object and ensure to hold the airplane in place so that the model unit will not take off.

Left stick pushing up Speed up

Speed down

Nose turn left

Nose turn right

descending

ascending

The body incline to left

The body incline

Left stick pulling down Left stick moving left Left stick moving right Right stick pushing up Right stick pulling down Right stick moving left Right stick

Instructions for Flight

Nose down/

Problem

Cause

Solution

Motor does not run

1. Battery is not fully charged. 2. The battery of transmitter is

not sufficient

3. Check the wire connection inside the model

4. The motor do not work due to impact or damage.

5. The frequency binding of the radio system fails

4. Change a new motor

No reaction for the

control surface

1.

2.The servo is damaged

1. Check the connection of 2.Change another servo.

Can not fly straight

1.The rudder is not in the center position of the airframe

2.The main wing is not fixed in the center position of the airframe.

1. Adjust the trim switch on the transmitter

2.Re-assembly the main wing

Can not climb

1. Charger the battery

2. Adjust the inching switch on the Transmitter.

Limited control range

Throttle

Troubleshooting

2. Install a new set of batteries 1. Charge the battery. 3. Please contact your local

distributor

5. Please rebind the unit

properly or inversely inserted. The servo wire was not inserted

the servo wire