RAID installation guide

Launch the NVRAIDMAN application and right click on the RAID array that you want to delete (assuming that you have a RAID array already created) as shown in the following

* To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows, including those for which you have a device support disk from a mass

If there are physical drives available, the Select RAID Level screen appears again, where you can create an additional logical drive.. Click the Logical Drive in Tree View to see

To confi gure the SATA RAID functions, you must fi rst use the Intel ICH7R/ICH9R SATA RAID Utility program to confi gure the RAID Level that you desire before install- ing the

During Intel Developer Forum Spring 2005, Intel presented a study showing the probability of failure on a RAID 5 system in three different configurations, supporting the conclusion

If you insert two HDDs to JMicron SATAII connectors and plan to configure RAID functions, please refer to JMicron RAID installation guide part, including JMicron BIOS RAID

This function allows you to manually create RAID arrays, allowing better flexibility over what was offered when setting up automatically. 1) Enter the Setup Utility and select

Fixed UEFI Microsoft Windows Server 2008* R2 SP1 installation on SCU ports may fail under RSTe RAID mode.. Fix UEFI Operating System installation is not supported on ESRT2 mode