• No results found

Bounds for the Ratio of Two Gamma Functions

N/A
N/A
Protected

Academic year: 2020

Share "Bounds for the Ratio of Two Gamma Functions"

Copied!
84
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 2: �α, β�-domain where qα,β�t� decreases on �−∞, ∞�.
Figure 3: �α, β�-domain where qα,β�t� is increasing on �0, ∞�.
Figure 5: �α, β�-domain where qα,β�t� is increasing on �−∞, 0�.

References

Related documents

shows the power wave obtained for CMOS current mirror which is combined in IHC circuit to reduce the common mode signals,. thus both the combination increases the circuit

Figures 5 and 8(b) clearly shows that the critical pressure of compaction is 70MPa, this pressure is sufficient to ensure re-arrangement of powder particles, resulting in

This paper reveals how this enhancement technique enhances color image as well as removal of speckle noise from the digital images.. Quantitative measures are done by using peak

Assistant Professor, Department of Automobile Engineering, Bharath Institute of Science and Technology, Bharath University, Chennai, India.. Professor, Department of

Temperature was calculated from line intensity ratios of successive ionization stages of iron and using six Fe I spectral lines for measured the plasma electron

The gene identity of 154 ENU-induced revertants shows that the distribution of alleles between three possible suppressor genes differs from that induced by

Structure at the levels of social form (monogyne, polygyne) and region (Corrientes, Formosa) was studied by calculating hierarchical and single-level Fstatistics for the

A pitch of 20 mm gives the highest thermal efficiency of 83.5% for and element height of 1.5 mm and reported heat transfer coefficient of roughened duct is 1.25 to 1.4