• No results found

Nortel Ethernet Routing Switch 5000 Series Configuration - Quality of Service. Release: 6.2 Document Revision:

N/A
N/A
Protected

Academic year: 2021

Share "Nortel Ethernet Routing Switch 5000 Series Configuration - Quality of Service. Release: 6.2 Document Revision:"

Copied!
210
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1 "Service Classes" (page 20) describes the service classes and their required treatment.
Table 5 "Default mapping of DSCP to QoS class and IEEE 802.1p" (page 38) describes the default DSCP, QoS class, IEEE 802.1p, and egress queue assignment for packets in each traffic class.

References

Related documents

DECOMPOSITION OF TIME-SCALES IN LINEAR SYSTEMS USING DOM INANT EIGENSPACE POWER ITERATIONS AN D MATCHED ASYMPTOTIC

Source: Snapshot of the website as of 16 June 2010, downloaded from web.archive.org The data indicate that, rather than using tax records to serve the public interest (e.g.

The configuration information of the performance library C:\WINNT\system32\w3ctrs.dll for the W3SVC service does not match the trusted performance library information stored in

If found, and the destination address is located at different port from this packet comes in, the Ethernet Switch will forward this packet to the port where this destination

For Simple Network Management Protocol (SNMP) or Telnet management, you can use any virtual router interface address to access the switch as long as routing is enabled on the

Flow record NetFlow match ipv4 tos match ipv4 protocol match ipv4 source address match ipv4 destination address match transport source-port match transport destination-port

TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY

If found, and the destination address is located at a different port from this packet comes in, the Industrial Fast Ethernet Switch will forward this packet to the port where this