Tablet Charging Wall Mount 12
Full text
Related documents
Podemos constatar que este horizonte de escenarios predispone a la Región Centro Occidente, en especial al Estado de Guanajuato, como el clúster automotriz más dinámico de
Remove the wall strap then drill holes and insert appropriate wall plugs. Reposition strap and fix using appropriate screws for
Mark the 8 holes (4 at each hinge) on the wall for securing. The centerline should run through the center holes. NOTE: The customer may move the location of the mounting screws up
Mount the control interface directly on a wall, as shown in Mounting Methods at right, using screws (not included). When mounting, provide sufficient space for
After hanging the hood on the bracket, remove the grease filters, mark 2 holes inside the hood for safety screws.. After marking, remove the hood, drill two holes and insert 2
□ Place the key holes in the decorative cover mounting plate (MM) over the two screws (JJ) previously loosened from the mounting ring (WW).. Turn the decorative cover
Use the security hex key supplied to turn the cover mounting screws clockwise to remove the cover from the dryer.. Place the hand dryer base on the wall at the desired location
Drive Screws through mounting holes in Base and into pilot holes until the Mounting Bracket is securely attached to the mounting surface.. Attach Receiver to Mounting Bracket, then