• No results found

Optimal Placement of Phasor Measurement Unit Using Ant Colony Optimization

N/A
N/A
Protected

Academic year: 2020

Share "Optimal Placement of Phasor Measurement Unit Using Ant Colony Optimization"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig.9 Optimized PMU locations for IEEE 14-Bus System

References

Related documents

TimeQuest Timing Analyzer Quick Start Tutorial © December 2009 Altera Corporation After you generate the Summary (Setup) report, generate a clock hold check summary for the design

1) When the gearbox under different working conditions, the vibration signals are acquired by acceleration sensors at a sampling frequency. 2) Partition the measured vibration

[9] proposed a 3D gradient magnitude based stereo FRIQA where they calculate pointwise 3D gradient magnitude similarity (3D-GMS) along horizontal, vertical and viewpoint directions

Small businesses often want to select from the range of services; perhaps they already have trade insurance, or perhaps a very strong credit controller, but often they

If the device does not run, for whatever reason, such as no oscillator, a faulty power supply connection, shorts on the target board, etc., then the debug executive cannot

A method of sensored field oriented control for induction motor can be found in application note AN908 “Using the dsPIC30F for Vector Control of an ACIM” (see “References”)..

Establishes rebuttable presumption of pretrial detention for defendants subject to mandatory term or presumption of imprisonment.. CURRENT VERSION OF TEXT

In the …rst stage the manufacturer indicates which retailers he is willing to trade with (conditional upon reaching an agreement on the transfer price). The manufacturer may choose