• No results found

Design and Performance Evaluation of Shell and Tube Heat Exchanger for Methylene Di Chloride

N/A
N/A
Protected

Academic year: 2020

Share "Design and Performance Evaluation of Shell and Tube Heat Exchanger for Methylene Di Chloride"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table No. 1 CFD results forwater
Table No. 2 CFD results for Methanol :

References

Related documents

After comparing the CMSP-STHX with a conventional shell-tube heat exchanger with segmental baffles (SG-STHX) by means of computational fluid dynamic (CFD)

Above fig shows CFD analysis and result of Temperature plot of Cold fluid of Square with Fillet cross section tube Heat Exchanger.. Fig 14: Temperature plot of hot fluid of Square

In pipe tube heat exchanger experiment setup is a useful tool for analyzing different fluid properties for find-out heat transfer rate of fluid and heat effects on water

Results obtained from standard analytical calculations changing different parameters of the heat exchanger such as baffle spacing and tube pitch layout and their effect on

Effectiveness is says the overall performance of heat exchanger, the Effectiveness of the modified heat exchanger is high comparing with segmental heat exchanger,

Contrary to heat exchanger theory however, there was no noticeable difference in the heat transfer rate between parallel flow and counter current flow. The counter current flow

Now, choose other method of design the shell & tube heat exchanger, we get the different result values for the shell side heat transfer coefficient &

Lunsford 1998 evaluated the increasing heat exchanger performance through a logical series of steps as follows; to consider if the exchanger is initially