• No results found

Processing and Characterization of a New Composite Metal Foam

N/A
N/A
Protected

Academic year: 2020

Share "Processing and Characterization of a New Composite Metal Foam"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1Matrix alloying elements in composite foams (mass%).
Fig. 2Composite metal foam comparison under monotonic compression.
Table 3Compositional analysis and corresponding Vickers Hardness ofphases in aluminum matrix (atomic %) in cast sample.
Fig. 5SEM image of 1.4 mm hollow sphere LC steel composite foam withdashed line showing the wall thickness of one sphere (note that the cut isnot through the center of the spheres).

References

Related documents

The ethno botanical efficacy of various parts like leaf, fruit, stem, flower and root of ethanol and ethyl acetate extracts against various clinically

Experiments were designed with different ecological conditions like prey density, volume of water, container shape, presence of vegetation, predator density and time of

It was decided that with the presence of such significant red flag signs that she should undergo advanced imaging, in this case an MRI, that revealed an underlying malignancy, which

These were backed up by substantial budgetary allocations, but agricultural output is still very low (Ojo, 2011). Therefore, the general objective of this study is to establish

19% serve a county. Fourteen per cent of the centers provide service for adjoining states in addition to the states in which they are located; usually these adjoining states have

The objective of this study was to develop Fourier transform infrared (FTIR) spectroscopy in combination with multivariate calibration of partial least square (PLS) and

MEAN DAILY WEIGHT GAINS AND INTAKE OF MILK