• No results found

Effects of Drill Points on Glass Fibre Reinforced Plastic Composite While Drilling at High Spindle Speed

N/A
N/A
Protected

Academic year: 2020

Share "Effects of Drill Points on Glass Fibre Reinforced Plastic Composite While Drilling at High Spindle Speed"

Copied!
7
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig 1 High speed spindle experimental setup
Fig 3 Effect of feed and spindle speed on delamination
Fig 5 Hole diameter for (a) Standard twist drill
Fig 8 Worn out regions of (a) Twist drill (b) Zhirov point  (c) Multifacet drill

References

Related documents

“Every school board shall adopt, after consultation with the advisory committee on services for handicapped students and students with social maladjustments or learning

The following exploratory research questions guided this investigation: (a) What are master’s-level counseling trainees’ levels of global trait EI, cognitive empathy,

The list identifies all of the potential home hazards that may cause a fall.. If the item applies to your home, place a check in

DEVELOPMENT OF EFFECTIVE CUCKOO SEARCH ALGORITHMS FOR OPTIMISATION PURPOSES BY MAHLAKU MARELI A dissertation submitted for the partial fulfilment of the requirements for the

Implications for nursing and policy: The fact that scores on the Stressors in Nursing Students scale increased over four years of the programme and males scored higher than

In summary, we report increased functional connectivity between executive regions of the prefrontal cortex and areas of the occipitoparietal cortex mediating the direction of

This value gives a more normalised estimate of the maximum values of the signal (no influence of local maxima). We measure the spreading by subtracting the 10%-quantile from

Volume   3:   Telnet,   SSH,   and   Syslog