• No results found

Programmable Voltage/Current Output Source with Overflow of Voltage/Current Protection Circuit

N/A
N/A
Protected

Academic year: 2020

Share "Programmable Voltage/Current Output Source with Overflow of Voltage/Current Protection Circuit"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1.Functional block diagram of the schematic circuit

References

Related documents

Thus, any circuit which is supposed to drive the input to a TTL gate must concentrate on sinking current, and only needs to source a little current when the driver output voltage is

Three cases were measured: DWDM lasers supplied by a laboratory voltage source (used as a current source), then one of the voltage sources was exchange to a laser driver, and finally

The inverter design is followed by regulation of the output voltage amplitude in response to the source voltage fluctuations and the output current variations resulting from

a. In the figure below a current source and a voltage source are connected in parallel with a resistor.. In the figure below a current source and a voltage source are connected

The maha dasha of Jupiter, Venus, Mercury, and the Moon will be easier than the maha dasha of malefic planets Saturn, Mars, Rahu, Ketu, and the Sun.. Jupiter will give some

2Ø12 NCPDP

Eseller-Bayat (2009) used an experimental setup called CSSLB to test partially saturated sands at lower degrees of saturation under cyclic simple shear conditions on

Evidence for the evaluation was gathered from a range of sources and approaches including: Dementia Care Mapping; interviews with family carers of people attending HLDC;