• No results found

PARAMETER OPTIMIZATION WHILE DRY TURNING AISI 1045 STEEL USING CBN TOOL BY RESPONSE SURFACE METHODOLOGY

N/A
N/A
Protected

Academic year: 2020

Share "PARAMETER OPTIMIZATION WHILE DRY TURNING AISI 1045 STEEL USING CBN TOOL BY RESPONSE SURFACE METHODOLOGY"

Copied!
14
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1  (a)Central Composite Design                        (b)Box-Behnken Design
Table 1: Chemical Composition
Table 3: Experiments Designed Using Central Composite Face Centred Design
Table 4: Experimental Results
+6

References

Related documents

For desired initial and final Cartesian positions of the toe of the swing foot, compute the initial joint posi- tion vector ф in and the final joint position vector ф f using

All questions can be discussed thoroughly, at the end of the learning, the lecturer model gave reinforcement and explanation of the material that has not been

The two sure fragments from the lower body (Group 2) show that the rhyton tapered gradually into a piriform shape rather than into the narrower bottom spout of the more

Abstract —This paper presents an ultra-wideband (UWB) high temperature superconducting (HTS) bandpass filter (BPF) based on a ring resonator loaded with a pair of

Importantly, all samples from the two datasets can be clearly classified into two groups, tumor group and normal group, based on the selected differentially expressed genes

From experiment it was found that fruit bar with 99% pulp and 1% omega-3 fatty acid was found to be best in every aspect of organoleptic analysis, microbial, physio-chemical

Importantly, both analog-6 and -7 effectively inhibited replication of hepatitis C virus in Huh-7.5.1 cells, with an IC 50 that is comparable to that of IFN- α 2a; and