www.jembellish.blogspot.com Page 1
The Lesa Bag
www.jembellish.blogspot.com Page 2 I would recommend using upholstery fabric for this bag to help it hold its shape. If you wanted to use thinner more lightweight fabric you can, it will just
make the bag much softer. You could add interfacing to lightweight fabric to make it stiffer. The inner fabric can be any kind you choose.
Materials needed: Main outer fabric:
1 x Main back: 30 x 29cm (11.75 x 11.5”) 1 x Front: 30 x 19cm (11.75 x 7.5”) 1 x Front: 30 x 11cm (11.75 x 4.25”) 2 x Sides: 26 x 6cm (10.25 x 2.5”) 1x Base: 30 x 6cm (11.75 x 2.5”) 1 x Strap: 103 x 10cm (40.5 x 4”) 2 x Strap loops: 14 x10cm (5.5 x 4”)
(OR FOR NON-ADJUSTABLE STRAP 1 x Strap: 110 x 10cm (43.25 x 4”) 2 x Front Pockets: 12 x 12cm (4.75 x 4.75”)
2 x Front Pocket flaps: 12 x 8cm (4.75 x 3.25”) 2 x Front Pocket sides: 34 x 4cm (13.5 x 4.5”)
Inner Fabric: 2 x Main bag: 30 x 29cm (11.75 x 11.5”) 1 x Front: 30 x 19cm (11.75 x 7.5”) 1 x Front: 30 x 22cm (11.75 x 8.5”) 2 x Sides: 26 x 6cm (10.25 x 2.5”) 1x Base: 30 x 6cm (11.75 x 2.5”) 2 x Front Pockets: 12 x 12cm (4.75 x 4.75”) 2 x Front Pocket flaps: 12 x 8cm (4.75 x 3.25”)
2 x Front Pocket sides: 34 x 4cm (13.5 x 4.5”) 2 x Inside Pocket: 24 x 16cm (9.5 x 6.25”)
2 x D rings for adjustable strap
3 x zips: 1 X 20cm (8”) or longer, for inside pocket. 2 X 30cm (11.75”) or longer, for outer zips
www.jembellish.blogspot.com Page 3 All seams are 3/8” unless otherwise specified.
First you are going to make the front pockets.
Take the square pocket pieces and pin the side pieces around three sides, right sides together. Repeat this for all 4 pocket pieces – 2
inside and 2 outside fabric.
Note: the side strips will hang over the third edge of the square a little – don’t worry, you trim this off afterwards.
www.jembellish.blogspot.com Page 4 Then stitch around those three edges, stitching in a curve at the
corners:
Trim the excess fabric to straighten the top edges of the pockets:
Now pin together one outer fabric and one inner fabric pocket right sides together. Pin all around, but leave a gap at the top to turn it
www.jembellish.blogspot.com Page 5 Stitch around the edges.
Then turn out, and top stitch around all the edges – including stitching the gap closed.
www.jembellish.blogspot.com Page 6 Now to the top flaps of the pockets.
Take the flap pieces and fold in half lengthways.
Measure 3cm (1.25”) down from one open end (not the fold). Then cut diagonally across to the fold from here like this:
Repeat this for all 4 flap pieces (2 inner and 2 outer fabric). You can use the one you have cut as a guide rather than measuring
www.jembellish.blogspot.com Page 7 Now pin the cut flaps together. One inner and one outer piece, right
sides together. Once again leave a gap at the top to turn the pieces out when finished.
Stitch around the edges, then trim the corners before turning right sides out.
www.jembellish.blogspot.com Page 8 Now you need to put a buttonhole in each pocket flap at the centre
point. Use the button hole setting and foot on your machine and a seam ripper to open the hole afterwards. Make sure you make the
hole the right size for your chosen buttons!
Now place the pocket flap centrally over the top of a pocket piece to find where the button needs to go.
www.jembellish.blogspot.com Page 9 So now you’re ready to attach your pockets to the front of your bag.
Fold the larger of the front pieces of the bag
(30 x 19cm (11.75 x 7.5”) in half to find the centre and mark with a pin.
Then place the two pockets on either side of the centre and pin around the sides and bottom.
www.jembellish.blogspot.com Page 10 Make sure you pin the edges so the pockets sit up from the bag and
not flat. And check the pockets look straight and even before you stitch!
Top stitch both pockets into place around the sides and bottom. At the top edges, run your stitching over the edges backwards and
forwards a few times for extra strength.
www.jembellish.blogspot.com Page 11 Next, place the flaps over the tops of the pockets and pin then stitch
into place securely.
Again run your stitches over the edges of the flaps a few times for added strength.
www.jembellish.blogspot.com Page 12 Now to piece together the front of the bag.
Lay one of your outer zips face down along the top of the front pocket piece, then the inner fabric front piece the same size on top.
www.jembellish.blogspot.com Page 13 Then turn both pieces of fabric back on either side of the zip, and topstitch. This will keep the fabric out of the teeth of the zip when
you open and close it.
Now lay flat the inner fabric front piece you have remaining: 30 x 22cm (11.75 x 8.5”)
Then lay your front pocket piece face up on top, and finally your remaining front outer fabric piece face down on top of that.
www.jembellish.blogspot.com Page 14 Pin and stitch across the top again using your zipper foot.
Then once again pull the fabric back from the zip – this time the inner fabric down – as this is the backing of the front pocket, and the
outer fabric up. Then top stitch.
www.jembellish.blogspot.com Page 15 Now to the inside pocket of the bag.
Take one of your large inner pieces of fabric, and lay one of your inner pocket pieces on top, where you want the pocket to be. Pin in
place.
Now using a pencil and ruler draw where the zip opening will be, using the zip itself as a guide:
www.jembellish.blogspot.com Page 16 Then stitch around this rectangle you have just drawn.
Then using your scissors – cut a line down the centre, and clip the corners:
www.jembellish.blogspot.com Page 17 Now push the pocket through the hole you just cut, then press flat.
Now pin your zip behind this pocket.
www.jembellish.blogspot.com Page 18 Next, flip over this piece and pin your other inside pocket piece to
the back of the pocket. You may need to trim the edge a little to size.
Pin all the way around, then stitch.
www.jembellish.blogspot.com Page 19 Now to the strap.
Take your long strap strip. Fold the top end over a little, then each side inwards. Then fold the whole thing over to hide all the raw
edges.
Then pin and stitch along both long edges and across the end you folded and pinned too.
www.jembellish.blogspot.com Page 20 Now for the strap loop.
Place the two pieces right sides together and stitch along both sides.
Turn this right sides out and top stitch along both sides. Now you have your strap and loop ready with the D rings for your
adjustable strap.
If you do not want an adjustable strap – then you just need to make the long strip and don’t worry about the loop. In this case you just
need one strip 110cm long (43.25”)
Now take a scrap of fabric approx. 12 x 5cm (4.75 x 2”) and fold it in on itself towards the centre lengthways, then in half to hide the raw
www.jembellish.blogspot.com Page 21 Now wrap this strip around your strap loop like so:
Slide off and stitch together:
Then slip this loop and the two D rings onto your strap loop; fold it in half and stitch the edges together:
www.jembellish.blogspot.com Page 22 Now you are ready to assemble your whole bag.
Place the front section of your bag face up. Then lay your final outer zip face down at the top, and finally on top of this one of your main
inner pieces.
If your zip is wider than the fabric – just let it hang over either end as shown in this picture– you will secure and trim the ends later.
Pin across the top, then stitch all 3 layers together using your zipper foot.
As you did with the front zip. Pull the inner and outer fabrics back from the zip and top stitch to prevent them catching in the teeth of
www.jembellish.blogspot.com Page 23 Now place your inner piece with pocket face up, then lay the front pieces of the bag face up on top of that with the zip facing upwards.
Finally lay your outer back piece face down on the top.
Pin and stitch again using your zipper foot.
www.jembellish.blogspot.com Page 24 Now open your bag out so you have the zip in the centre and the
front and back laid flat:
Now first make sure your main zip is open a little, then take your strap and strap loop and pin then stitch on either side of the main zip
with the raw edges lined up with the raw edges of the bag:
Note here that if you are not making an adjustable strap, you simply attach either end of the strap to the sides of the bag – making sure
www.jembellish.blogspot.com Page 25 Stitch both sides securely, running 2 or 3 rows of stitching along each
side.
www.jembellish.blogspot.com Page 26 Now take the side pieces of the bag and pin the short edges face down, across the sides of the zip where you just attached the strap pieces. Pin the outer and inner fabrics on either side of the main bag,
www.jembellish.blogspot.com Page 27 Now open the bag so that you have the outer fabric on one side of
the zip, and the inner fabric on the other side. Pin the front and back panels to the side pieces.
Then stitch using a 5/8” seam to ensure you catch in all the seams and zips.
www.jembellish.blogspot.com Page 28
Before you continue – check that the main zip of the bag is OPEN!!! This is very important!
Finally, attach your two base pieces to the inner and outer parts of the bag. Pin and stitch all the way around the base of the outer bag,
but leave a gap of around 20cm (8”) in one seam of the inner bag – to allow turning the bag right sides out!
www.jembellish.blogspot.com Page 29 Now turn your bag right sides out through the gap in the inner base.
Then pin the gap closed.
And stitch. I machine stitched, as this will be at the bottom of the inside of the bag and so not visible. But if you like, you can hand
www.jembellish.blogspot.com Page 30 Your bag is now finished!
If you have made an adjustable strap – thread the strap through both D-rings, then tuck the end back through one and slip through the
small loop holder you
www.jembellish.blogspot.com Page 31 And your bag is ready to fill and use!
www.jembellish.blogspot.com Page 32 Note about adjustable strap.
I made a few of these bags using denim and upholstery fabric with no problems with the strap. However, one bag I made used quite slippery fabric, which did have a tendency to slip through the D-rings.
To avoid any ‘slipping’ you could add a button to the strap loop and several button holes to the end of the strap for an adjustable length.
If you have any questions of comments regarding this tutorial. Please do not hesitate to contact me at:
