• No results found

External mechanical work done during the acceleration stage of maximal sprint running and its association with running performance

N/A
N/A
Protected

Academic year: 2020

Share "External mechanical work done during the acceleration stage of maximal sprint running and its association with running performance"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1. Changes in GRFs and displacement in the position of the center ofpressure during maximal sprint running.displacement in the center of pressure (COP) position (D) measured in thehorizontal anteriormaximal sprint running for one participant who was a
Fig. 2. Calculations of mechanical work. In each ofthe difference betweenminimumtoe-off (each step as the difference between the minimumoff (between Ekap (A), Ev (B) and Eext(C), the periods between landing and the point at which the energy valuebecomes mi
Fig. 4. Changes in work parameters over increasing %Vpresented data are means±s.d. The means and s.d
Table 3. Correlation coefficients between mechanical power and forceat every 10% Vmax from 20 to 100% Vmax
+2

References

Related documents

Bicycle Coalition of Maine – Augusta, ME Catholic Charities of Maine – Portland, ME Central Maine Newspapers – Portland, ME Central Maine Power Company – Portland, ME

If you choose not to tell us about your disability, provide this information with short notice before your course or examination/ assessment start dates or do not provide

Since 1938, Anthem Blue Cross and Blue Shield in Maine has proudly offered health care plans for Maine’s children, adults and seniors.. This long heritage includes serving every

tween stream faunas and forest type but extensive stream surveys in New Zealand (Rounick and Winter- bourn, 1982) indicate that the faunas of most small forest

In the liver and small intestine, which show high expression of CYP3A11 mRNA, PXR1 mRNA was highly expressed while PXR2 mRNA expression was low.. In the lung, kidneys, heart,

Community peer review is a method that extends the ethics of consent into scientific practices.. It

In general, for the combined bending and tension loadings, different limit load must be used to predict the J-integral for different points on the crack