• No results found

Critical Parameters Affecting Water Alternating Gas (WAG) Injection in an Iranian Fractured Reservoir

N/A
N/A
Protected

Academic year: 2020

Share "Critical Parameters Affecting Water Alternating Gas (WAG) Injection in an Iranian Fractured Reservoir"

Copied!
12
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1: Rock and reservoir fluid characteristics. Datum  depth (ft.) 6100-6210 Total pore  volume (MM Reservoir  barrel) 21.373 Average  reservoir  pressure  @ datum  depth (psia) 3035 temperature Reservoir (°F) 210 Reservoir oil  °API 35 Initial gas  sat
Figure 2: Relative permeability curves for oil wet rock  (from one of Iranian central oil field).
Table 3: The amount of MMP and FCMP for different  gases. C 1N2Solvent (40% C2 and  60% C 1 )CO2Component 64001460039803400First Contact Miscibility Pressure  (psia)  Simulated by  PVTI software 55001320039703000Minimum Miscibility Pressure (psia) Simulate
Figure 6: A value (recovery from economical view) at  different cycle times in water-wet rock (PVIT=1).
+5

References

Related documents

Primary liver resection and salvage transplantation or primary liver transplantation in patients with single, small hepatocellular carcinoma and preserved liver function:

Its principal purpose is to provide employment and business opportunities to its members and manage it in accordance with cooperative principles.. Categories of

This exchange mechanism is appropriate for any public data or higher assurance data if shared via a protected portal with appropriate access controls for incidents, indicators,

The planning options available within a SIPP mean that the accompanying investment strategy has to be both flexible and suitable to suit your needs and thus we will tailor

27 Yordan Gunawan, (2014), Transboundary Haze Pollution In the Perspective of International Law of State Responsibility, Jurnal Media Hukum, Volume 21, p.. 347 countries

300 Lb Steel preferred practice indicates that raised face on steel flange See Fig. raised face on the steel Full Face Carbon Steel, without heat treatment other than stress

organisations and margins and profits will be built into the costing models. Many of the interviewees have argued that the administrative burden of complying to regulations increase

Proof. Then the FOC of the private firms.. Interestingly, we find that the first best can be implemented through a constant tax on the public firm, coupled with a subsidy on the