• No results found

Design and Analysis of Gas Turbine Blade

N/A
N/A
Protected

Academic year: 2020

Share "Design and Analysis of Gas Turbine Blade"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1 shows the open cycle gas turbine in power station. Gas turbine consists of three main components
Figure 4 shows the first stage gas turbine rotor blade profile. Gas turbine have used this profiles which is specified by air foil terminology
Fig Meshing of first stage rotor blade
Figure 12 shows the temperature distribution for nickel material. The maximum temperature is observed at the leading edge surface and minimum temperature is observed at trailing edge surface of the rotor blade

References

Related documents

(a) SEM fractograph of region ‘‘A’’ of the fractured surface (b) Magnified view of the rectangular section, showing propagation of crack from leading edge towards trailing

This project summarizes how to design turbine rotor blade geometry, and predict that geometry is safe on the basis of static structural analysis (based on elongation

Little pressure drop takes place in leading edge passage as comparedto pressure drop in serpentine and trailing edge passage, this supports experimental findings..

Veeraragavan Effect Of Temperature Distribution In 10c4/60c50 Gas Turbine Blade Model Using Finite Element Analysis.. Timoshenko, “STRENGTH OF MATERIALS PART 1”

The efficiency of the wind turbine has increased by 5% when rough surface blade are used and 6% when flap at trailing edge are used while compared to the wind turbine using smooth

In a previous numerical study [2] the predicted tip heat transfer for a sharp edge tip and a radiused tip (blade tip with a rounded edge around the perimeter of the blade tip)

In contrast, temperatures of the blade at leading- edge are higher than those of the trailing edge as shown in Fig. 4b, which can be attributed to higher convective heat

The film cooling effectiveness and the resulting heat transfer coefficient on a cylindrical leading edge was studied experimentally with the help of a low-speed