Design And Embedded Controller (Swimming Pool Pump Timer)
Full text
Figure
Related documents
All Variheat AW models contain a heat recovery heat pump dehumidifier that is automatically controlled to remove unwanted humidity from the swimming pool hall and provide
8 P1 Water inlet temp sensor failure 9 P2 Water outlet temp sensor failure 10 P3 Gas exhaust temp sensor failure 11 P4 Evaporator coil pipe temp sensor failure 12 P5
NOTE: In order for the unit to be able to heat the swimming pool (or spa), the filtration pump must be in operation in order for water to be able to circulate via the heat pump5.
In the Second function interface,click “ ” to enter into the Temp Setting interface, slide up or down to select the target temperature, click “OK” to save the setting and
Any heat exchanger or electric heater fitted as auxiliary heating must be installed after (down stream from) the heat pump so as to avoid pre-heating the pool water before it
AT˖Ambient temperature COMP˖Compressor CT˖Coil temperature EP˖Exhaust protection EEV˖Electronic expand valve ET˖Exhaust temperature FM˖Fan motor FS˖Flow switch HP11˖High
=> If the pool requires heating, the indicator blinks for 2 to 3 minutes then remains on and the heat pump compressor + fan start up at the same time.. during the first
Sachs and Warner (1997), Gylfason (2008), and Gylfason and Zoega (2006) identify several ways in which resources could negatively affect the accumulation of physical capital. 9