• No results found

ANALOG-DIGITAL CONVERSION

N/A
N/A
Protected

Academic year: 2021

Share "ANALOG-DIGITAL CONVERSION"

Copied!
100
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 6.12: Single-Ended Level Shifter with Gain Requires Rail-to-Rail Op Amp
Figure 6.18: Input Circuit of AD7466 1.6-V to 3.6-V,  12-Bit, 200-kSPS SOT-23-6 ADC
Figure 6.19: Driving Single-Supply Data Acquisition ADCs With Scaled Inputs
Figure 6.20: Simplified Input Circuit for a Typical Switched Capacitor CMOS  Sample-and-Hold
+7

References

Related documents

If the input common mode voltage range is exceeded, the output will not display a phase reversal but it may latch in the appropriate high or low state.. The device can then be reset

The incremental design approach provides a secure guarantee that each stage of the migration can be fully validated to the satisfaction of the simulator tutoring and engineering

3 Mean value and standard error of calculated uniformity-related traits by the newly developed 3D image analysis software against de fined uniformity scale based on manual

1 TRANSFORMATION THROUGH DIGITALISATION: UNLOCKING CAPACITY AND CONNECTING COMMUNITIES 2 SIGNIFICANTLY ENHANCING CUSTOMER EXPERIENCE: PIONEERING INTELLIGENT MOBILITY 3

The low noise, wide bandwidth, and rail-to-rail input/output operation of the OP284 make it ideal for low supply voltage applications such as in the two op amp

The AD8041 not only has ample signal swing capability to handle the dynamic range required without using a sync tip clamp but also has good video specifications like differential

The OP162/OP262/OP462 have a wide output voltage range that extends to within 60 mV of each supply rail with a load current of 5 mA.. Decreasing the load current extends the output

800 μV maximum input offset voltage 2 μV/°C typical offset voltage drift 25 pA maximum input bias current Low noise: 13 nV/√Hz @ 10 kHz APPLICATIONS.. Battery-powered