• No results found

Increasing the gap tolerance in friction stir welded joints of AA6082-T6

N/A
N/A
Protected

Academic year: 2021

Share "Increasing the gap tolerance in friction stir welded joints of AA6082-T6"

Copied!
195
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 2.1:   Input parameters and tool used for AA 6082-T6 from  literature  [14] [15]
Table 2.4:  Welding parameters for EN-AC 46000 FSW with weld gaps  [9]
Figure 2.4:  Cross-section of joints obtained without powder at 400 and  100 mm/min (A: advancing side; R: retreating side)  [4]
Figure 2.19:  A surface breaking void in the weld produced at  400mm/min  [34]
+7

References

Related documents

Figure 15: RMS power consumption for 6 packs of compressors, with cases & cold rooms participating in the secondary FFR DSR event, based on the candidacy algorithm,

Here, we identified a natural epiallele of rice ESP and found that plants carrying this epiallele show reduced panicle size, as well as hypomethylation in the ESP

Field experiments were conducted at Ebonyi State University Research Farm during 2009 and 2010 farming seasons to evaluate the effect of intercropping maize with

In the testing phase of this research uses two testing, testing the first testing the strength of the encryption process after ciphertext randomness using

19% serve a county. Fourteen per cent of the centers provide service for adjoining states in addition to the states in which they are located; usually these adjoining states have

diallylacetic acid rather than bismuth since in one case in which analysis was performed only minute amounts of bismuth were recovered, and there was, in his opinion, ‘ ‘no

It was decided that with the presence of such significant red flag signs that she should undergo advanced imaging, in this case an MRI, that revealed an underlying malignancy, which