• No results found

Influence of Cutting Factors on the Cutting Tool Temperature and Surface Roughness of Steel C45 during Turning Process

N/A
N/A
Protected

Academic year: 2020

Share "Influence of Cutting Factors on the Cutting Tool Temperature and Surface Roughness of Steel C45 during Turning Process"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table -2: C45 Physical and Mechanical Properties, Prasanth [12-13].
Table-3: Experimental training dataset, [15].
Fig - 7: Temperature and surface roughness against depth of           cut for dry and coolant at N=900 rpm and S=0.1 mm/rev
Figure 10 shows the relationship between temperature and surface roughness against feed rate for dry and rpm
+2

References

Related documents

I designed a three-stage analysis: of Korean women’s job continuity after childbirth without career interruption, of patterns in labor force return after any career interruption,

The study is designed to demonstrate that IORT using a low-energy x-ray source delivered to the tumor bed of the resected pancreatic cancer followed by standard adjuvant

(2006) investigated the influence of price and brand loyalty of three frequently purchased product categories on the purchase decision process of store brands

Invasive whole plant Stem, leaves and flowers are used as general tonic as well as for the treatment of liver problems and constipation.. Seeds along with honey are also used

- El rolido y el recobro El nado en aguas abiertas también implica que los triatletas deban realizar un mayor rolido movimiento de rotación del tronco que se produce para realizar

Hindawi Publishing Corporation Advances in Difference Equations Volume 2009, Article ID 143175, 14 pages doi 10 1155/2009/143175 Research Article On the Spectrum of Almost Periodic

Abstract —This paper presents an ultra-wideband (UWB) high temperature superconducting (HTS) bandpass filter (BPF) based on a ring resonator loaded with a pair of