• No results found

Constant temperature induced stresses in evacuated enclosures for high performance flat plate solar thermal collectors

N/A
N/A
Protected

Academic year: 2020

Share "Constant temperature induced stresses in evacuated enclosures for high performance flat plate solar thermal collectors"

Copied!
13
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 2. Conceptual depiction of a 0.25 m2 vacuum flat plate solar thermal collector.
Table 1
Fig. 3. Mesh refinement for (a) vacuum glazing case 1 and (b) vacuum glazing case 2.
Fig. 5. Atmospheric pressure induced principal stress on 4 mm thickexternal glass cover surface in vicinity of 6 mm diameter support pillar for60 mm pillar spacing.
+6

References

Related documents

V tem poglavju sem z analizo dolgov v zaključnih računih na primeru pomurskih občin iz bilance prihodkov in odhodkov, računa finančnih terjatev in naložb ter računov

We studied the influence of the type of anchor and the definition of improvement on the estimates of the SDC and the MIC of the NDI in a sample of patients with general,

Methods: This study analyzes the determinants of energy demand change to clarify the factors that have affected the fluctuations in regional energy demands in Japan, using

The crude extract and the fraction exhibiting the lowest IC50value were also tested for AR inhibitory activity using kidney enzyme solution of diabetic mice in order

One point to note is that TD SRM ETD method allows a higher selectivity and specificity for the identification of this Hb variant compared to HPLC and other protein analysis

In this subsection the annual thermal energy delivery for solar collectors for different vertical incline angles, the influence of the various collectors’ positioning on SEA

Proktors prompepulver” by Jo Nesbø PRODUCERS Cornelia Boysen and Synnøve Hørsdal for Maipo Film AS RELEASE March 7, 2014 SALES TrustNordisk FESTIVALS. Norwegian

This structural phase exhibits a strong inhomogeneity at the milling times shorter than 6 h (the asymmetry of α peaks in the patterns), but, it improves, when the milling