• No results found

Simulation of Fluid Structure Interactions by using High Order FEM and SPH

N/A
N/A
Protected

Academic year: 2021

Share "Simulation of Fluid Structure Interactions by using High Order FEM and SPH"

Copied!
11
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1: Typical problems with FSI.
Figure 2: Convergence rates of the h-, p- and hp-Version FEM for a two dimensional linear problem with singularities [6].
Figure 3: Central particle with neighbor particles, influence area and kernel function [18].
Figure 4: Two rows of boundary particles (brown) that prevent the fluid particles (blue) from penetrating the boundary and FE nodes (orange) with the area of influence, from which the fluid pressures are averaged.
+3

References

Related documents

• Information obtained through exploratory actions may affect the probabilities of later outcomes?. – Recall that the probabilities on later outcomes can be conditioned on

Altech offers a wide variety of products used in conjunction with Ring Sensors, Analog Sensors, Namur Sensors, testers and power supply modules for all sensor prod- ucts..

The ratio of MMP7 over total protein concentration was, however, not sig- nificantly different in saliva samples obtained from periodontitis patients relative to controls (Fig. 1

The absence of tourist spots or cultural heritage sites that can be developed in the municipality, however, should not preclude Santo Tomas from being a complimentary cog

Race condition is an error in clinical programming software which results when two processes try to access the same resource and the result depends on the transaction of

Passed time until complete analysis result was obtained with regard to 4 separate isolation and identification methods which are discussed under this study is as

4.1 You represent and warrant to Company that (i) you have the corporate power and authority to request the Services in connection with the domain indicated in your Application and

Methods: The heart rate is analyzed using the various time domain parameters, frequency domain parameter and nonlinear parameters like Poincare geometry, ApEn, LLE and DFA.. Results: