• No results found

Surface Modification and Wear Properties of Direct Metal Laser Sintered Hybrid Tools Used in Moulds

N/A
N/A
Protected

Academic year: 2020

Share "Surface Modification and Wear Properties of Direct Metal Laser Sintered Hybrid Tools Used in Moulds"

Copied!
9
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1.  Chemical composition of the tested steel materials [17] to [19]
Fig. 1.  The test specimen a) after the wear test, b) confocal microscopic image
Fig. 2.  The 2D profile of the worn
Fig. 8.  Core hardness of MS1 and W722 steels in different heat treatment conditions
+4

References

Related documents

Pithawalla College Of Eng... Institute

He also provided members with information about the opportunity for Boards to set up a virtual office account with the Criminal Records Division free of charge which would permit

To explore the relative performance of the two methods further, we conducted additional simulations with e β = 4 under an “intermediate event rate” scenario with n = 500,

The construction of a fish pond is typically shown in Fig. Ponds are constructed along coastal area in the south coast of Madura Island. During high tides, seawater floods the

Third, different from Arnold (1998) and BHP (2000), long- run growth in our model depends not only on preferences and the human (and physical) capital accumulation technologies,

Therefore, the objectives of this work were to: (1) study the main morphologic differences intermarmoset individuals for analyzing the variabil- ity regarding sperm

Materials and Methods: The specificity of the assay was tested using reference strains of vancomycin-resistant and susceptible enterococci.. In total, 193