• No results found

Optimization of Cutting Parameters for Surface Roughness in Turning of Alloy Steel EN 47

N/A
N/A
Protected

Academic year: 2020

Share "Optimization of Cutting Parameters for Surface Roughness in Turning of Alloy Steel EN 47"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 3 : the result of experiment with surface roughness () values
Table 5 : S/N response table for factor
Table 7 : Result of the confirmation experiment

References

Related documents

Intui- tively, the model shows that when the cost of the test is rather low, the price the health authority fixes when the firm carries out R&D investment is higher than the

Abstract —This paper presents an ultra-wideband (UWB) high temperature superconducting (HTS) bandpass filter (BPF) based on a ring resonator loaded with a pair of

No significant association with oral cancer was observed for the two SNPs under all the five genetic models. In addition, stratified analyses by ethnicity revealed null association

Transferable Multi-model Ensemble for Benign-Malignant Lung Nodule Classification on Chest CT; Proceedings of the Medical Image Computing and Computer-Assisted

In this study, the LARS inhibitor could significantly inhibit tumor cell prolifera- tion by targeting intracellular LARS in a dose-dependent manner, which suggests that

In the fully Bayesian statistical infer- ence the t-channel signal strength is extracted simultane- ously by using either the BDT or NN discriminator output in the two signal

(A) Extracts from wild-type and rosy mutant medflies display XDH enzyme activity when hypoxanthine or xanthine are used as a substrates. Similarly prepared Drosophila extracts serve

Coriandrum sativum (coriander) and Lactuca sativa (lettuce) were transplanted in soil mixed with human excreta at a ratio of 40:1 containing 3log 10 cfu/g soil of a mixture