• No results found

Size, Shape and Flow of powders for use in Selective Laser Sintering (SLS)

N/A
N/A
Protected

Academic year: 2021

Share "Size, Shape and Flow of powders for use in Selective Laser Sintering (SLS)"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 2. PSD of EOS HP3, EOS PA2200 and PEEK-OPTIMA®
Figure 6. EOS HP3 at medium magnification
Table 1 AOR results
Table 2 AOR results of dried and sieved materials  ______________________________________________

References

Related documents

Consequently, when Paul directs us to walk in Christ after the same fashion in which we received Him, we can see at least this much: the Christian walk does not honor the

These analyses involved various experiments; the phytochemical content of coconut ( Cocos nucifera ) oil were evaluated, determined the susceptibility pattern against

Moreover, safety knowledge is a key factor mediating the effect of various safety management practices (management commitment, safety training, employees'

The panel of experts highlighted the existence of sev- eral unmet needs. 1) Patients diagnosed with ARD require a specific classification that gives prominence to the causative

In developing countries, the high level of income and wealth concentration seen in countries like China, India, Brazil, South Africa -- much higher than in developed countries

If consideration of new research evidence is positioned as a rational mode function, and current practice as an expe- riential mode function, then the factors which influence

From Figure 1.1 shows five main steps in this research methodology. The research methodology begins with the APA simulation so as to prove the existence of