ABB i-bus KNX Switch Actuator, x-fold, 16/20 A, MDRC SA/S x , 2CDG 110 1xx R0011

In addition to the well-proven function options, the application pro- gram for the C-Load types offers an additional copy and exchange function for parameterised output channels..

Uses potential free contacts to switch 2, 4, 8 or 12 independent electrical loads via the ABB i-bus ®.. Manual operation and display of the switching state of

 Switch Actuators are responsible for reliable switching of different electrical loads in the KNX system..  Many different load situations

Using the parameter Value object Switch on bus voltage recovery, it is also possible to define if the channel switches on (staircase lighting time times out normally) or off.. If

If the output is switched on and a “0” is sent to the “Operation mode” object, the staircase lighting function swit- ches on and the output is switched off after the preset time.

3/18 Forced operation Output A, Master 1 bit (EIS1) CW Sets a fixed fan speed and valve position for the fan coil controller and disables them 4/19 Toggle heating/cooling Output

 Using symmetric algorithms for payment card data invites

None of reference is invalid, drug information to opioids under the references from a group of the technologies we cannot show you already on our pdr.. Just some electronic access