• No results found

Service Level Based Capacity Rationing Procedure for Make-To-Order Manufacturing Systems

N/A
N/A
Protected

Academic year: 2020

Share "Service Level Based Capacity Rationing Procedure for Make-To-Order Manufacturing Systems"

Copied!
16
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1. Flowchart representing the decision procedure.
Figure 1 illustrates profit in each case and
Figure 2. Profit of protecting q −tj
Figure 4. Incremental expected objective value.
+3

References

Related documents

For each of these simulations, the network latency was held constant at the equivalent of 8192 reg-ops; context-switching overhead was set to 16 reg-ops; and the instruction

For example, the interaction structure (i.e. the assumptions over the set of channels connecting agents and conveying information at each point in time among them) is either of

Average dispersion measurement standard deviation versus period for Rayleigh and Love wave group and phase speeds, where the average is taken over all acceptable measurements....

In compliance with Government Code section 54957.5, non–exempt writings that are distributed to a majority or all of the Board in advance of a meeting, may be viewed at 201

Rowley (2006) in his analysis of value-added approaches in the Victorian context argues for a multilevel model, which is a more complex approach that can show the relative impact at

Select Health of South Carolina considers the use of neuropsychological testing (NT) to be clinically proven and, therefore, medically necessary to determine the

2 On November 4, 2010, the director of the National Cancer Institute (NCI) announced that an ongoing evaluation of the National Lung Screening Trial (NLST) data had shown

The German X-ray Ordinance/Radiation Protection Ordinance stipulate that both a Master’s and a Bachelor’s degree (B.Sc. or B.Eng.) in the physical-technical field constitute