• No results found

3D Printing : depowdering techniques

N/A
N/A
Protected

Academic year: 2020

Share "3D Printing : depowdering techniques"

Copied!
53
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1: Depiction of steps in Sinter Laser Melting (SLM) (Britannica, 2017).
Figure 2: 3D printed manifold with complex channels
Figure 3: Aluminum Pixel (AlSi10Mg).
Figure 6: Percentage powder removed over the angle orientation.
+7

References

Related documents

Saat ini dengan memiliki karakter seorang wirausaha yaitu rasa percaya diri yang beliau miliki dalam mengembangkan usahanya membuat beliau mampu bertahan sampai sekarang

Because the feed rate is negligible in front of the cutting speed on the main edges of the tool, the thrust force generated is mainly related to the chip height.. As far as

A single procedural rule can be used to generate many 3D models. For example, the rule can make use of feature attribute information stored in GIS data – such as, the number of

Rationale for considering universal glove use (in addition to Contact Precautions for patients with known CDI) on units with high CDI rates. • Although the magnitude of

At Tavant, we had been using commercial tools QTP and QC (formerly known as Mercury Test Director) for functional test automation and test management, respectively.. We wanted to

Given this background this study set out to analyze the economic efficiency of the three existing forest management approaches of Kakamega forest as well as

The application of the new insulating material on site certainly requires specific application procedures to be followed, especially if the Vendor is asked to provide

Doing so can result in the instrument overturning, damage to the tone bars or frame, or causing injury to you or others.. • Do not use the mallets for anything other than playing the