• No results found

Optimization method of complex electronic device test point

N/A
N/A
Protected

Academic year: 2020

Share "Optimization method of complex electronic device test point"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1:The schematic diagram of filter circuit

References

Related documents

The elec- tron diffraction patterns suggest the crystallographic structure of the nanodomains in these two compositions is identical to that of the shell in the x = 0.06

The objective of a protection scheme in a power system is to minimize hazards to personnel and equipment while allowing the least disruption of power service. Short

New Mexico State University associate professor and Athletic Training Program director Kim O'Connell-Brock (center) guides students Xochitl Alvarado (left) and Julie Jacquez through

First, when read operation is processed in degraded mode , regeneration for failed disk block always requires N-1 disk access in traditional RAID5 systems, reading N-2 data

Soil and Water Assessment Tool (SWAT) was successfully used to simulate, the impact of climate change on the hydro climatology of Finchaa sub-basin were assessed based on

These appliances typically are flexible to shift load to other times (dishwasher), or flexible to dial down (immersion water heater). 3) Users with better behavioural control will

11/ These obstacles include the following: a) The international humanitarian system does not take sufficient account of national actors, and should change to ensure it does so;

Equipped with up to 16 powerful Intel Xeon quad-core processors, and state-of-the-art visualization and storage capabilities, the Cray CX1 supercomputer delivers