• No results found

Research and Design of the Measurement and Control System of Low temperature Plasma Equipment Based on CAN Bus and Ethernet

N/A
N/A
Protected

Academic year: 2020

Share "Research and Design of the Measurement and Control System of Low temperature Plasma Equipment Based on CAN Bus and Ethernet"

Copied!
9
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Figure 1. The structure of the cryogenic plasma equipment system.
Figure 2. The measurement and control system of low temperature plasma based on CAN-Ethernet
Figure 3. The program flow of the CAN-Ethernet gateway.
Figure 4. Real-time test 1 of PDO communication.
+2

References

Related documents

There were five different ways to build the circuit designs which are Voltage Doubler and Cockcroft-Walton’s Voltage Multiplier, Marx generator, Tesla coil and Flyback power

• Power requirements: The equipment must be powered using the delivered medical approved AC/DC power supply (Class II).. • The medical approved AC/DC power supply must be powered by

These multistage cascade bias voltage supply circuit ensure a low noise and high efficiency of the power supply system... The design

Stimulating the enthusiasm of young volunteers for environmental protection, 1000 Environment-Friendly Youth Ambassador Action Program encourages and supports their active

6 – System of distributed power supply of the railroad contact grid: БП – basic converter, ВЧК – high-voltage high- frequency cable, ПП – sub-supply point, КС – DC

Department: Curriculum and Instruction page 8 MA Information Packet (MA) Traditional Master’s Degree (MA) September 9, 2015 Content Courses: English, Math,

Alcohol or Drug Addiction Program  No,  federal  TANF  program  funds  cannot  be  used  for  medical  services,  except  for  pre‐pregnancy  family 

This Agreement is made between the Champaign-Urbana Public Health District and the County of Champaign and Champaign County Health Department pursuant to the