• No results found

Improvement of Mechanical and Electrical Properties on the Sintered Ni 50 mass% Cr Alloys by HIP Treatment

N/A
N/A
Protected

Academic year: 2020

Share "Improvement of Mechanical and Electrical Properties on the Sintered Ni 50 mass% Cr Alloys by HIP Treatment"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1SEM photographs of the surface morphology: (a) electrolysis Ni powders, (b) reduction Cr powders and (c) Ni­50 mass% Cr alloypowders after 1 h ball mixing.
Fig. 2OM morphology observations of Ni­50 mass% Cr alloys by various sintering temperature treatments (a) 1325°C, and (b) 1345°C.
Figure 4 shows the SEM morphology observations of the
Figure 7 shows the electrical resistivity tests of Ni­

References

Related documents

Figure 3.1.2 showed that the device avalanched once the voltage was pushed past 6.5 volts and that the method works as intended. Comparing this graph with the one in Figure 3.1.1

Since the core Member States are posing directly requests towards the external border ones for being responsible for an asylum request, although it is known that countries

As of January 2014 the IWGSC released genome survey sequence assemblies [1] , population sequencing (POPSEQ) data and Genome Zipper data as well as annotated chromosome 3B

Hence the present investigation was undertaken for drug candidate physico chemical characterization, to develop a simple and robust UV Spectrophotometric Method

To investigate the power available to infer topology weightings from short sequences, we simulated data- sets under a range of sampling strategies and demographic scenarios, and

acoustic systems still usable for recovery. This proved a bad judgement. On return to 109 in May, we failed to find either mooring; possibly the pinger

Hydrogen atoms were placed at calculated positions (C–H 0.93–0.97 Å) and were treated as riding on their parent atoms,. with U (H) set to 1.2–1.5 times U

The cell esds are taken into account individually in the estimation of esds in distances, angles and torsion angles; correlations between esds in cell parameters are only used