• No results found

Problems of introduction of innovative technologies 3d printing in Kazakhstan

N/A
N/A
Protected

Academic year: 2020

Share "Problems of introduction of innovative technologies 3d printing in Kazakhstan"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Table 1. The story of the three-dimensional printing
Fig. 3 Types of technologies that are common in Russia [6]
Fig.6 The State should become a participant of the process of

References

Related documents

In theory, FRET is a radiationless energy transfer process, so ideally, a single emission spectrum of the output fluorophore should be observed, as illustrated in Fig.2.7

19% serve a county. Fourteen per cent of the centers provide service for adjoining states in addition to the states in which they are located; usually these adjoining states have

Хат уу буудай нъ ТгШсит ёигит зүйлд хамаарагддаг нэг настай ихэечлэн зусах хэлбэртэй үет ургамал бөгөөд уураг ихтэй, шилэрхэг үртэй, натур жин их байдгаараа

Comparing and analyzing the initial population and selected wavelength for boiling point, it is observable that, both 100 and 400 initial population don’t produce

Background: Previously reported results of a prospective, randomized placebo-controlled study showed that the pollen extract (Cernilton) significantly improved total symptoms, pain,

Roilides E, et al : Disseminated infection due to Chrysosporium zonatum in a patient with chronic granulomatous disease and review of non- Aspergillus fungal infections in patients

Methods: Three patients with a history of food dependent exercise induced urticaria/anaphylaxis and food panaller- gen sensitization in whom a food-exercise challenge was not

It was decided that with the presence of such significant red flag signs that she should undergo advanced imaging, in this case an MRI, that revealed an underlying malignancy, which