MERIT LILIN ENT. CO., LTD
http://www.meritlilin.com
INSTRUCTION MANUAL
D/N VANDAL RES. VARI-FOCAL DOME CAMERA
PIH-2342X/2346X W/S
IMPORTANT SAFEGUARDS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
GRAPHIC SYMBOL EXPLANATION
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of
uninsulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and
m a i n t e n a n c e ( s e r v i c i n g ) i n s t r u c t i o n s i n t h e l i t e r a t u r e
shock to persons.
PART DESCRIPTION & DIMENSION
BASE
DOME COVER
Unit
mm
136.0
55.0
99.5
HOLE PLUG
SIDE HOLE
INSTALLATION
2. Put the provided screws (M3.0 x 25, wooden screw) through
the holes marked as "a", and fix the base in the desired area
(FIG.1).
1. Please use the enclosed screw driver to untighten the 4
tamper-proof screws on the dome cover.
FIG. 1
a
a
a
3. Firstly, put video cable and power cable through a pipe with
1/2" PT at one end (FIG.2), and connect the cables to the
terminal block on the PCB accordingly and then screw the
pipe to the side hole (FIG.3, please make sure the
connection between the pipe and the side hole is watertight.).
Pipe is not provided.
NOTE :
FIG. 2
FIG. 3
VIDEO
GND
VIDEO
OUT
POWER
INPUT
FOCUS OR ZOOM ADJUSTMENT
4. The direction of the lens is adjustable through the adjustable
Pan/Tilt brackets and rotatable round bracket for Azimuth.
The lens can be adjusted easily by hand without using screw
driver. Please refer to FIG.4.
5. An extra RCA jack for easy installation. Plug the video input
of monitor to the RCA jack and adjust focus and zoom.
After finished, unplug the RCA jack. Please refer to FIG.5.
FIG. 5
FIG. 4
TILT
PAN
BRACKET
ZOOM OR FOCUS ADJUSTMENT
IRIS LEVER VR
SCREW DRIVER
6. Adjust DC iris level by turning the iris level VR.
Please refer to FIG.4.
ATTENTION: Adjust this VR with care so as not to cause
damage to the unit.
7. Put on the dome cover first. Then tighten the tamper-proof
screws (FIG.6).
Alternative cabling positions
2. Put the video cable and power cable through the bottom
hole and connect them to the terminal block on the PCB
accordingly. Please refer to INSTALLATION Step3 for
water-resistant installation.
1. Untighten the hole plug on the bottom of the base and screw
it to the side hole.
3. Fix the cable with cable clamp.
VIDEO
GND
VIDEO
OUT
POWER
INPUT
Design and specifications are subject to change without notice.
D/N VANDAL RESISTANT VARI-FOCAL DOME CAMERA Model No.
Power Input Voltage System Sync. Mode Pick Up Element Effective Pixels Chip Size Scanning System Resolution Minimum Illumination S/N Ratio
Auto Gain Control
Aperture Correction Power Consumption Back Light Compensation Video Output Gamma Characteristic Lens Operating Temperature Weight Dimension DC12V ( 10%) NTSC or PAL Internal 1/3" Super HAD CCD Sensor
5.59mm (H) x 4.68mm (V)
2 1 Interlace
Color: 540TV Lines, Mono: 600TV Lines Color: 0.05Lux at F1.4, 0Lux with IR Mono: 0.01Lux at F1.4
More Than 50dB (AGC OFF) 36dB Variable Gain Horizontal , Vertical 2.2W Auto CVBS 1.0Vp-p , 75ohm =0.45 -10 ~ +50 (14 ~ 122 ) Base : 136 x 55mm , Dome : 91.8 768(H) x 494(V) [NTSC] 752(H) x 582(V) [PAL] 15.734KHz / 59.94Hz [NTSC] 15.625KHz / 50Hz [PAL] Horizontal & Vertical
Sync. Frequency Focal Length Iris
Angle of view
White Balance ATW
1200g H V D 3.3~12mm F1.4 63.6 ~ 17.9 89.8 ~ 23.9 125.7 ~ 29.9 IP Rating IP68 PIH-2342XWN/P
SPECIFICATIONS
Vandal Proof Withstand a blow from a 10 lbs sledgehammer Infrared Cut Filter
9~22mm 23.3 ~ 9.8 32.1 ~ 13.1 41.9 ~ 16.3 PIH-2342XSN/P Auto Selectable
Design and specifications are subject to change without notice.
D/N VANDAL RESISTANT VARI-FOCAL DOME CAMERA Model No.
Power Input Voltage System Sync. Mode Pick Up Element Effective Pixels Chip Size Scanning System Resolution Minimum Illumination S/N Ratio
Auto Gain Control
Aperture Correction Power Consumption Back Light Compensation Video Output Gamma Characteristic Lens Operating Temperature Weight Dimension DC12V ( 10%) or AC24V (10%) NTSC or PAL Internal 1/3" Super HAD CCD Sensor
5.59mm (H) x 4.68mm (V)
2 1 Interlace
Color: 540TV Lines, Mono: 600TV Lines Color: 0.05Lux at F1.4, 0Lux with IR Mono: 0.01Lux at F1.4
More Than 50dB (AGC OFF) 36dB Variable Gain Horizontal , Vertical 3.0W (DC12V) , 2.5W (AC24V) Auto CVBS 1.0Vp-p , 75ohm =0.45 -10 ~ +50 (14 ~ 122 ) Base : 136 x 55mm , Dome : 91.8 768(H) x 494(V) [NTSC] 752(H) x 582(V) [PAL] 15.734KHz / 59.94Hz [NTSC] 15.625KHz / 50Hz [PAL] Horizontal & Vertical
Sync. Frequency Focal Length Iris
Angle of view
White Balance ATW
1200g H V D 3.3~12mm F1.4 63.6 ~ 17.9 89.8 ~ 23.9 125.7 ~ 29.9 IP Rating IP68 PIH-2346XWN/P
Vandal Proof Withstand a blow from a 10 lbs sledgehammer Infrared Cut Filter
9~22mm 23.3 ~ 9.8 32.1 ~ 13.1 41.9 ~ 16.3 PIH-2346XSN/P Auto Selectable
Automatic Switch From Color Mode To Monochrome