EXPRESS 6503 SHDSL ATM DSU User Manual
Full text
Figure
Outline
Related documents
Copy the file to the destination router with the copy tftp: flash: commandB. Enable the TFTP server on the source router with the tftp-server flash: <filename>
To make it work, you must have a tftp server installed and copy the firmware file to the tftp server.. Input the tftp server address >> 192.168.1.1 Input the file name
thus to rapidly multiply the numbers of infected adult mosquitoes — is the reason why it is important to use insecticide treated-bednets with yellow fever patients. After
First configure your tftp server on the phone and then power cycle or reboot the phone. Please consult user manual for detail. How do I setup my tftp server on the phone? There are
21 If the card is not getting its TFTP information correctly, check the TFTP service on the Cisco Unified Communications Manager and make sure it is running. 22 Check the TFTP trace
Two protocols, Trivial File Transfer Protocol (TFTP) and Dynamic Host Configuration Protocol (DHCP) must be available for the HomeBase Server to be capable of deploying the
If you do not use DHCP on your network to identify TFTP servers, or if you want the device to use an alternate TFTP server, then you need to manually configure your TFTP server from
From a HyperTerminal session on router R1, begin the TFTP upload to the TFTP server using the copy running-config tftp command.. Respond to the prompts as