• No results found

On the Minimization of Power Consumption in Base Stations using on/off Power Amplifiers

N/A
N/A
Protected

Academic year: 2020

Share "On the Minimization of Power Consumption in Base Stations using on/off Power Amplifiers"

Copied!
6
0
0

Loading.... (view fulltext now)

Full text

Loading

Figure

Fig. 1: Power flow in the Base Station.
Fig. 2: Power vs. switching energy for different traffic conditions and various switching frequencies.
Fig. 3: Power vs. switching frequency, for various traffic conditions, different Pidle and Psw = 100 W.
Fig. 6: Relative Gain vs. Pidle for different switching frequencies, different traffic conditions and Psw = 100 000 W.

References

Related documents

These results provoked considerable controversy, with some maintaining that the improvements were caused by a participation effect tied to the extra attention and care offered to

Moreover, the growth opportunities of these cross-listed firms are likely to be more valuable not only because the firms are better able to take advantage of them, but also because

Cardiovascular risk and acute coronary syndrome in giant cell arteritis: a population based retrospective cohort study. Arthritis Care

We …nd that the growth rate of average human capital during transition is highest whenever the network has both of the following two characteristics: (i) there are many nodes linked

Field Tech Computer (Temporary Service Connection) Managed Field Ethernet Switch Sign Controller Interface See Note 1 SPD OR See Note 4 Electrical Breaker SPD UPS See Note 6

until the onset of cirrhosis, resulting in changes in interpersonal relationships. Social Support for transplant candidates is an important variable, providing them with

A yeast two-hybrid screen reveals an important interaction between the C. elegans Grb2 homolog, SEM-5, and EGL-15: To identify potential signaling components that might bind directly

Most interesting fact is that, all available modules of S1, S2, S3 are pin to pin compatible, so no need to change a single wire in final design, if I require a higher range